I had the original reflash done and noticed no difference whatsoever. I personally don't think the dealer did it, they have yet to produce any paperwork saying that it was done- and I've asked them 3X in the last 6 months. I think I'm going to take it to another dealer for the 20k service and see if they will do the latest reflash.
TSB 07-2-3 (Update for 06-21-11)
*Update for 06-21-11*
http://us.f13.yahoofs.com/bc/43dafb42mc9a58637/bc/Fusion+TSB+PDF+Files/tsb07-02-03+(update+for+06-21-11).pdf?BCFjkZGBHyGvsyb9
FORD: 2006-2007 Fusion
LINCOLN: 2006 Zephyr
MERCURY: 2006-2007 Milan
This article supersedes TSB 06-21-11 to update the TSB Action step.
ISSUE:
Some 2006-2007 Fusion, Milan and 2006 Zephyr vehicles built before 9/4/2006 equipped with a 3.0L engine and Aisin F21 automatic transmission may exhibit one or more of the driveability and/or transmission symptoms listed below.
Engine Driveability
Diagnostic trouble code (DTC) P0606
Powertrain lacks response
High idles after starting engine and lasting about 2 minutes
Intermittent hard to start
Transmission
Transmission shifts too early / too late / too often
Gear changes take too long to complete
Shifts rough or jerky from park
Slow downshifts
Takes too long to engage and/or hesitates while shifting from Park to Drive or Reverse
ACTION:
Reprogram the powertrain control module (PCM) and transmission control module (TCM) to the latest calibration
http://us.f13.yahoofs.com/bc/43dafb42mc9a58637/bc/Fusion+TSB+PDF+Files/tsb07-02-03+(update+for+06-21-11).pdf?BCFjkZGBHyGvsyb9
FORD: 2006-2007 Fusion
LINCOLN: 2006 Zephyr
MERCURY: 2006-2007 Milan
This article supersedes TSB 06-21-11 to update the TSB Action step.
ISSUE:
Some 2006-2007 Fusion, Milan and 2006 Zephyr vehicles built before 9/4/2006 equipped with a 3.0L engine and Aisin F21 automatic transmission may exhibit one or more of the driveability and/or transmission symptoms listed below.
Engine Driveability
Diagnostic trouble code (DTC) P0606
Powertrain lacks response
High idles after starting engine and lasting about 2 minutes
Intermittent hard to start
Transmission
Transmission shifts too early / too late / too often
Gear changes take too long to complete
Shifts rough or jerky from park
Slow downshifts
Takes too long to engage and/or hesitates while shifting from Park to Drive or Reverse
ACTION:
Reprogram the powertrain control module (PCM) and transmission control module (TCM) to the latest calibration
1 - 2 of 15 Posts
Let me describe a problem and see if any of you V6 guys had this and the TSB fixed it. When I come to a stop sign and make less than a total and complete stop, it's like the car shifts to 1st and then jerks badly when I take off. If I'm sitting at a light and take off, then it shifts fine. It like the trans should have gone to 2nd at the stop sign but went to 1st instead. It's impossible to take off smoothly if I don't come to a total stop and sit for several seconds.
Anyone else had this problem?? Thanks
Anyone else had this problem?? Thanks
1 - 2 of 15 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
FordFusionClub.com
A forum community dedicated to Ford Fusion and all Ford vehicle owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance for the Focus, Fiesta, Taurus, Mustang and more!
Full Forum Listing
Recommended Communities
