FordFusionClub.com banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have a 2007 Fusion SE V6 without auto temp, the car was overheating so shop replaced waterpump and thermostat which fixed the overheating problem. The heater occasionally blew cold air before the repair, but only blows cold air now. Could this be a stuck blend door or is the heater core going out now? Also read about blower motor resistor but that sounds like that is for fan speed and not temperature. Any help would be greatly appreciated.

Thanks.
 
1 - 1 of 1 Posts
Top