FordFusionClub.com banner

1 - 2 of 2 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
About to have someone change my rear bumper cover on a 2008 ford fusion,dual exhaust,park assist,does anyone have diagrams, photos or videos or know where i can find them,youtube I could only find 2013 model.that walk you through it?the person doing it for me wants exact locations of all the bolts,clips etc,any help will be greatly appreciated,thanks.
 

·
Registered
Joined
·
2,011 Posts
There's five or so push-retainer type clips from the bottom.
Remove each tail light and there's a screw or clip underneath each light.
Remove the push-retainers at the back half of the rear wheel inner liners. There's likely going to be a screw at the very front-most part of the bumper screwing into the quarter panel.
Use a plastic putty knife to separate the clips along the part where it mates to the quarter panel. Look carefully in the gap.

Just take your time and follow all the edges, should only take 15 minutes or so. Of course, remove it slowly because there's license plate lamp wiring still attached to the bumper.
 
1 - 2 of 2 Posts
Top