[quote author=fusion9 link=topic=199950.msg4133930#msg4133930 date=1319115572]
Greetings:

Car has been good to me so far 52000miles.
I noticed my compass was getting stuck in the same N positon.
So I was playing around and I put zone 8 in instead of 11.

The message after says to go in a circle..3-5mph...approx 3 times.

Do I leave that message displayed ON while doing this??
Is there a way to start over to get back to zone??? Tried to get it
back to zone screen but doesn't work.
Can I disconnect the battery to start fresh??

Thnxs
Walt
[/quote]

Hi Walt. :wavey: The instruction concerning how to recalibrate the compass, determine/set proper zones etc. are in the Owners Manual. Check the Index under "Compass, electronic set zone adjustment" for the correct pages in your copy.

Good luck. :cheers:

 

Thxs for the fast reply.

Yup..followed the instructions...wasn't calibrating..
Will try again, and vacant parking to make it work properly.

Walt

 

Update:

Went to an empty parking lot did 1.5 turns 3mph-right hand turns and the calibration-screen said updated(Emergency brake alarm went off when completed). Going around the block didn't work...

Walt